All electrical installation work will comply with BS7671:2018
and any amendments in force at the time of the works.
All electrical installation work will comply with applicable
Building/Wiring Regulations in force at the time of the works.
Where work is to extend or modify existing circuits, costs
given assume that the existing installation is in adequate condition and complies with minimum current regulations. Any works found required to bring the necessary parts of the existing installation
up to standard will be at additional cost.
Unless stated otherwise, all cables will be concealed by
chasing into the building fabric or concealed in building voids, under floors, etc. Where impracticable, cabling will be neatly surface run, either clipping direct or housed in
trunking/conduit.
Where carpet or flooring coverings may require lifting to allow
concealed installation work, no charge is made for this service, with best endeavours being made to avoid damaging them and to refit them to an acceptable standard. However, consideration of
employing a specialist fitter may be prudent, at your cost to effect a fully satisfactory reinstatement.
Where agreed before hand, chases to walls, etc will be
re-filled flush, however final sanding and final decoration is excluded.
All endeavours will be made to undertake installation work to a
clean standard, using dust sheets and vacuum cleaning equipment as necessary.
If appropriate, CDM Regulations 2015 will apply. For more
information on current HSE regulations visit their website: www.hse.gov.uk
For all domestic clients, it shall be assumed that suitable
welfare provisions are available, namely, appropriate wash/toilet facilities, access to clean water etc and that reasonable requirements are made to provide a safe place of work. You are also
responsible for the notification to us of any asbestos or asbestos containing materials in or around the property where work will be taking place.
Exclusions:
Clearing and/or moving of furniture and other items blocking
access to work areas are not included.
Except where detailed, builders work (creating of holes larger
than 50mm diameter, creating of support structures, etc) are not included, except as outlined in 1d, e and f above.
Re-decoration and final making good is excluded from given
costs, unless specifically detailed as included.
Removal from site and disposal of rubble, fittings, wiring,
materials, general waste and packaging of client’s goods are not included.
Any faults arising from an existing electrical installation
where a re-wire or new installation has not been installed. For example, a replacement consumer unit is more sensitive so existing faults may not be evident. The the addition of an electrical socket
or light fitting can have the same impact. To ensure the safety of the electrical installation, such faults must be rectified but may be at an additional cost.
Extras and
Variations:
All extras and variations must be agreed in writing prior to
commencement.
Pricing:
The costs given assume continuous and unhindered access to the
site and to carry out said work, however, some work may be hindered by weather which is beyond our control.
Unless stated otherwise, the costs given assume standard
working hours between 08:00–17:00 hrs Monday to Friday inclusive. Work required outside these hours may attract out of hours premium rates.
Any additional work not covered in our estimate will attract a
day rate of £35.00 per hour plus materials cost.
Due to a constantly changing market, all figures given are
valid for 14 days from the date of the estimate.
Verbal acceptance of this estimate also deems that you have
read and agreed to the terms and conditions set out here.
Deviations from Building Regulations and
BS7671:
All work where applicable, will be executed fully in compliance
with applicable Building Regulations and BS7671 (including any amendments) in force at the time of the work, particularly in respect of work in dwellings to allow the legal Part P obligations to be
met. Where a Client requires any deviation from such regulations, they will be advised on the implications and, if possible, any alternatives available. You are strongly urged to reconsider any
deviation from the current Building Regulations and BS7671 as this could result in a non-compliant installation. In these circumstances a written instruction and record will be required and the
client would be advised to seek the services of their local Building Control to certify the said work. Please be aware that this will be subject to their own fees and if found to be non-compliant,
you will be required to rectify the work at your own cost.
Risk and Title of
Goods:
The risk of all goods supplied shall pass to the Client upon
delivery.
All goods supplied shall remain property of SDS Electrical Ltd
until all sums due have been paid in full.
Warrantee:
SDS Electrical Ltd warrants its installation work to be defect
free for a period of twelve months from invoice date. Such cover does not extend to goods not supplied by SDS Electrical Ltd, including light bulbs, physical damage to products, or any instance where
the original installation has been altered or tampered with subsequently by third parties.
Payment:
Unless agreed in writing payment in full must be made on
completion of the specified works within 7 days toSDS Electrical
Ltd.
For works over
£3000.00,SDS Electrical Ltdmay submit interim invoices, depending on the degree of work involved,
for appropriate amounts, with the balance then due on completion. Payment to be made within 7 days toSDS ElectricalLtd.